Utilization of a Microbubble Dispersion to Increase Oxygen Transfer in Pilot-Scale Bakerâ s Yeast Fermentation Unit
In the large-scale production of Saccharomyces cerevisiae (bakerâ s yeast), oxygen transfer, which is one of the major limiting factors, is improved by using high agitation rates. However, high agitation rates subject the microorganisms to high shear stress and caused high power consumption. A microbubble dispersion (MBD) method was investigated to improve oxygen transfer at low agitation rates and thus reduce power consumption and shear stress on the microorganisms. The experiments were conducted at the 1-liter level and subsequently scaled-up to 50-liters using a constant volumetric oxygen transfer coefficient (kLa) method for scaling. In comparison to a conventional air-sparged fermentation, the MBD method considerably improved the cell mass yield, growth rate and power consumption in the50-liter fermentor. Cell mass production in the MBD system at agitation rate of 150 rpm was about the same as those obtained for a conventional air-sparged system agitatid at 500 rpm. Power consumption in the conventional air-sparged system was three-fold that required for the same biomass yield in the MBD system. However, at the 1-liter scale, the MBD system did not show any significant advantage over the air-sparged system because of the high power consumption.
Advisor:John S. Cundiff; Foster A. Agblevor; William H. Velander; Allan A. Yousten
School:Virginia Polytechnic Institute and State University
School Location:USA - Virginia
Source Type:Master's Thesis
Keywords:biological systems engineering
Date of Publication:05/12/2000