Submergence Effects on Jet Behavior in Scour by a Plane Wall Jet
In the experiments, the range of submergence was varied from 3-17.5, whereas the range of densimetric Froude number and the ratio of the boundary roughness to the gate opening (relative boundary roughness) were varied from 4.4-6.9 and 0.085-0.137 respectively. The velocity field in the scour hole at asymptotic state was measured using a SonTek 16-MHz MicroADV. Time development of the characteristic dimensions of the scour hole was also measured.
The dimensions of the scour hole were found to increase with increasing submergence for all experiments with a bed-jet flow regime. In the bed-jet flow regime, the jet remains near the bed throughout the scouring process. Further, the time development of the scour hole dimensions were observed to increase approximately linearly with the logarithm of time up to a certain time before the beginning of asymptotic state for experiments with either the bed-jet or surface-jet flow regimes.
The flow field results showed that the velocity profiles in the region of forward flow and the recirculating region above the jet were similar in shape up to about the location of the maximum scour depth. Relationships describing this velocity profile, including its velocity and length scales, were formulated. The decay rate of the maximum velocity, the growth of the jet half-width, and the boundary layer thickness were also studied. The decay and the growth rate of the jet length scales were found to be influenced by the submergence ratio, densimetric Froude number, and the relative boundary roughness.
Two distinct stages in the decay of the maximum streamwise velocity, with distance along the direction of flow, were observed for the jet flows having a bed-jet flow regime. The first stage of velocity decay was characterized by a curvilinear decay of velocity, which followed that of a wall jet on a smooth, rigid bed for streamwise distance approximately equal to 2L. For the surface-jet flow regime, the decay of velocity was observed to be similar to that of a free-jump on a smooth, rigid bed for a streamwise distance approximately equal to L. Here, L is defined as the streamwise distance measured from the end of the rigid apron to where the maximum streamwise velocity in the jet is half the velocity of the jet at the end of apron. The streamwise maximum velocity of the jet was then seen to increase in what was called the recovery zone.
A relationship for the streamwise decay of the maximum velocity within the scour hole is proposed. Moreover, other scales representing the flow inside the scour hole such as the streamwise distance from the end of the apron to where the streamwise maximum velocity starts to deviate from curvilinear to linear decay and the streamwise distance to where maximum streamwise velocity starts to increase are suggested. Some new results on the velocity distribution for the reverse flow for a bed-jet flow regime are also presented. Finally, some dimensionless empirical equations describing the relationship between the jet scales for the jet flow in a scour hole and the scour hole size are given.
Advisor:Bugg, James; Sharma, Jit; Putz, Gordon; Kells, Jim; Mazurek, Kerry
School:University of Saskatchewan
School Location:Canada - Saskatchewan
Source Type:Master's Thesis
Keywords:densimetric froude number characteristic dimensions fo scour hole asymptotic state jet behavior boundary layer growth half width velocity decay scales submergence effect plane wall
Date of Publication:04/01/2008