Details

PULSED ULTRASONIC DOPPLER VELOCIMETRY FOR MEASUREMENT OF VELOCITY PROFILES IN SMALL CHANNELS AND CAPPILARIES

by Messer, Matthias

Abstract (Summary)
Pulsed ultrasound Doppler velocimetry proved to be capable of measuring velocities accurately (relative error less than 0.5 percent). In this research, the limitations of the method are investigated when measuring: in channels with a small thickness compared to the transducer diameter, at low velocities and in the presence of a flow reversal area. A review of the fundamentals of pulsed ultrasound Doppler velocimetry reveals that the accuracy of the measured velocity field mainly depends on the shape of the acoustic beam through the flow field and the intensity of the echo from the incident particles where the velocity is being measured. The ultrasonic transducer turned out to be most critical component of the system. Fundamental limitations of the method are identified. With ultrasonic beam measurements, the beam shape and echo intensity is further investigated. In general, the shape of the ultrasonic beam varies depending on the frequency and diameter of the emitter as well as the characteristics of the acoustic interface that the beam encounters. Moreover, the most promising transducer to measure velocity profiles in small channels is identified. Since the application of pulsed ultrasound Doppler velocimetry often involves the propagation of the ultrasonic burst through Plexiglas, the effect of Plexiglas walls on the measured velocity profile is analyzed and quantified in detail. The transducers ringing effect and the saturation region caused by highly absorbing acoustic interfaces are identified as limitations of the method. By comparing measurement results in the small rectangular channel to numerically calculated results, further limitations of the method are identified. It was not possible to determine velocities correctly throughout the whole channel at low flow rates, in small geometries and in the flow separation region. A discrepancy between the maximum measured velocity, velocity profile perturbations and incorrect velocity determination at the far channel wall were main shortcomings. Measurement results are improved by changes in the Doppler angle, the flow rate and the particle concentration. Suggestions to enhance the measurement system, especially its spatial resolution, and to further investigate acoustic wave interactions are made.
Bibliographical Information:

Advisor:Cyrus K. Aidun; Farrokh Mistree; Yves H. Berthelot; Philip J. W. Roberts

School:Georgia Institute of Technology

School Location:USA - Georgia

Source Type:Master's Thesis

Keywords:mechanical engineering

ISBN:

Date of Publication:09/07/2005

© 2009 OpenThesis.org. All Rights Reserved.