Details

FORGING PROCESS DESIGN FOR RISK REDUCTION

by Mao, Yongning

Abstract (Summary)
In this dissertation, forging process design has been investigated with the primary concern on risk reduction. Different forged components have been studied, especially those ones that could cause catastrophic loss if failure occurs. As an effective modeling methodology, finite element analysis is applied extensively in this work. Three examples, titanium compressor disk, superalloy turbine disk, and titanium hip prosthesis, have been discussed to demonstrate this approach. Discrete defects such as hard alpha anomalies are known to cause disastrous failure if they are present in those stress critical components. In this research, hard-alpha inclusion movement during forging of titanium compressor disk is studied by finite element analysis. By combining the results from Finite Element Method (FEM), regression modeling and Monte Carlo simulation, it is shown that changing the forging path is able to mitigate the failure risk of the components during the service. The second example goes with a turbine disk made of superalloy IN 718. The effect of forging on microstructure is the main consideration in this study. Microstructure defines the as-forged disk properties. Considering specific forging conditions, preform has its own effect on the microstructure. Through a sensitivity study it is found that forging temperature and speed have significant influence on the microstructure. In order to choose the processing parameters to optimize the microstructure, the dependence of microstructure on die speed and temperature is thoroughly studied using design of numerical experiments. For various desired goals, optimal solutions are determined. The narrow processing window of titanium alloy makes the isothermal forging a preferred way to produce forged parts without forging defects. However, the cost of isothermal forging (dies at the same temperature as the workpiece) limits its wide application. In this research, it has been demonstrated that with proper process design, the die temperature can be reduced greatly without violating process window constrictions. Moreover, the computation cost is also reduced by replacing the complex 3-dimensional (3D) shape with its corresponding 2-dimensional (2D) representative cross sections, and a well balanced load distribution has been achieved by proper design of die flashland.
Bibliographical Information:

Advisor:

School:The Ohio State University

School Location:USA - Ohio

Source Type:Master's Thesis

Keywords:

ISBN:

Date of Publication:06/26/2009

© 2009 OpenThesis.org. All Rights Reserved.