Development of wavelength modulation diode laser absorption spectrometry in transversely heated graphite atomisers for sensitive trace element analysis
The Wavelength Modulation Diode Laser Absorption Spectrometry technique (WM-DLAS) is a laser-based spectroscopic technique for sensitive detection of atoms and molecules that so far mostly has been used for environmental monitor-ing. This thesis is concerned with the development of this technique for sensitive trace element analysis. The WM-DLAS technique is in general able to measure a variety of species at three orders of magnitude lower concentrations than conven-tional atomic absorption techniques since it shifts the detection to high frequen-cies where the 1/f-noise is significantly lower. The WM-DLAS technique has in this work been combined with a Transversely Heated Graphite Atomiser (THGA) in order to make possible both ultra-sensitive trace element analysis and microanalysis. The new technique has shown a limit of detection of 10 fg ( g) for Rb in aqueous solutions (the pilot element under investigation), corresponding to a concentration of 0.2 ppt (0.2 parts-per-trillion or pg/mL). The work has been pursued along several lines. The most important one has been to obtain a thorough understanding of the physical processes that might influence the performance of the technique. This part of the work has, in turn, been pur-sued in two different directions; to identify and understand the processes that give rise to the analytical signal (in order to find means to maximize it), and to identify and understand the processes that give rise to background signals and their drifts (in order to find means to minimize them).A thorough understanding of the signal strengths and shapes of the analytical WM-DLAS signal has been obtained by the development and use of a program that simulates WM-DLAS signals for a variety of experimental situations. Quanti-ties of special importance have been the influence of laser centre frequency, fre-quency modulation amplitude, and the order of the harmonic detected on the signal strengths and shapes. The influence of hyperfine structure and isotope shifts on the elemental detection has also been investigated. It was found that the existence of hyperfine structure and isotope shift, as well as the pertinent broaden-ing mechanisms, has a pronounced effect on the detection. It was, in fact, found the WM-DLAS signal from a low pressure cell has little in common with that from an atmospheric pressure atomiser, such as the THGA, which puts sever restrictions on its use as a wavelength reference source. It has also been found that WM-DLAS is, in most situations, not limited by the shot noise, but rather noise and drifts from the background signals. A significant amount of work has therefore been devoted to identify these background signals so as to find means to minimize them. The investigation has revealed that the most important background signals originate from multiple reflections in optical components, so-called etalon effects. Various techniques for reduction of such background signals have been proposed and examined. Other research directions pursued have been to develop a new methodology for dealing with optically thick samples. This led to the development of a new tech-nique for extending the dynamic range of the WM-DLAS technique. The meth-odology does not require any prior knowledge of the analytical content of the sample, nor does it sacrifice the high sensitivity of the technique in order to obtain the extended dynamic range. The dynamic range was, by applying the methodol-ogy, increased to more than six orders of magnitude.
Source Type:Doctoral Dissertation
Keywords:NATURAL SCIENCES; Physics; Physics; Fysik; Physics; fysik
Date of Publication:01/01/2002