Details

Concurrent chip and package design for radio and mixed-signal systems

by Shen, Meigen

Abstract (Summary)
The advances in VLSI and packaging technologies enable us to integrate a whole system on a single chip (SoC) or on a package module. In these systems, analog/RF electronics, digital circuitries, and memories coexist. This new technology brings us new freedom for system integration as well as new challenges in system design and implementation. To fully utilize the benefits of these new hardware technologies, concurrent design of system, chip, and package is necessary. This research aims to explore the new design space and opportunities for System-on-Package (SoP), with special attention on radio and mixed-signal system applications. Global level system partitioning for SoC and SoP with cost-performance trade-off, concurrent chip and design for high-speed off-chip signaling, global clock distribution, and ultra wideband (UWB) radio module are two fields in this research.Cost-performance driven for mixed-signal system partitioning in early conceptual level design is first addressed in this thesis. We develop a modeling technique to pre-estimate the cost and performance. The performance model evaluates various noise isolation technologies, such as using guard rings, and partitioning the system into several chips. In cost analysis, new factors such as extra chip area and additional process steps due to mixed signal isolation, integration of intellectual property (IP) right module or “virtual components”, yield and technology compatibility for merging logic, memory and analog/RF circuits on a single chip are considered. An efficient computation algorithm, namely COMSI, is developed for cost estimation under various mixed-signal performance constraints.System interconnect topologies have been moving away from multi-point bus architecture and towards high-speed serial links. But low interaction between chip and package design has more and more limited system performance. We address concurrent chip and package design and co-optimization for high-speed off-chip signaling in this part. First we explore the interconnect and package constraints to the circuit and system architecture. Proper equivalent circuit models for package parasitics are set up and then a 3-dimension electromagnetic (EM) solver is used to extract the parasitic parameters of package. After that, bandwidth and noise of the signal channel are estimated. The optimal off-chip singling is designed according to these packages and interconnection constraints. We also analyzed the global clock distribution using co-design method.We developed a low cost, low power consumption, and low complexity UWB radio module using co-design method and SoP technologies. The module will be used in low data rate and long-range wireless intelligent systems such as radio frequency identification (RFID) or wireless sensors networks (WSN). Liquid-crystal-polymer (LCP) based SoP technologies were used to implement the module.
Bibliographical Information:

Advisor:

School:Kungliga Tekniska högskolan

School Location:Sweden

Source Type:Doctoral Dissertation

Keywords:TECHNOLOGY; Electrical engineering, electronics and photonics; Electronics

ISBN:91-7178-181-7

Date of Publication:01/01/2005

© 2009 OpenThesis.org. All Rights Reserved.