Details

A 2.4 GHz LC-VCO using on-chip inductors and accumulation-mode varactors in a CMOS 0.18 [mu]m process [electronic resource] /

by Williamson, Bryant Derand

Abstract (Summary)
The demand for low power, low cost, and low noise RF sub-systems has lead to the development of completely integrated transceivers. Frequency synthesizers containing a PLL and a crystal oscillator are perhaps the most challenging part of a transceiver's design. One of its nosiest, most power consuming components, the VCO, often makes the PLL a challenging design. For an LC-VCO, the best type of VCO for quality noise performance, the struggle lies in the fully integrated inductor. Despite the vast improvement in additional facets of the LC-VCO, the integrated inductor lags in its accomplishments; and the focus of designers is to work around the inductor's low quality factor. This research analyzes the LC-VCO and different means of compensating for design parameters hindered by a low-quality integrated inductor. It tests an LC-VCO developed in a 0.35 [mu]m CMOS, 3.3V process and also designs an LC-VCO in a 0.18 [mu]m CMOS, 1.8V process. The VCO design has a center frequency of 2.4 GHz. Also, its components and topology are scrutinized, while its performance is analyzed and verified through simulation results.
Bibliographical Information:

Advisor:

School:The University of Tennessee at Chattanooga

School Location:USA - Tennessee

Source Type:Master's Thesis

Keywords:

ISBN:

Date of Publication:

© 2009 OpenThesis.org. All Rights Reserved.